The Everbuild EVBGFSC5 dual purpose foam cleaner is used to remove wet / uncured foam from brick, PVCu, plaster etc. This EVBGFSC5 simply attaches to Everbuild gun foam applicator for purging through, also includes spray nozzle for use without applicator to remove wet foam from outside of the gun and from most building substrates.
Easy to use with some simple steps: Pull the trigger on the gun to release the solvent into the gun barrel and discharge the solvent into a suitable container for disposal. Only stop discharging the cleaner when the solution being ejected from the gun is completely clear. Leave the gun foam cleanse attached to the gun for 5 minutes to allow the solvent in the gun to work on the residues inside. Pull the trigger once again until only clear solvent emerges. Leave for a further 5 minutes and repeat this process 2 or 3 times until the gun is completely clear.
500ml.
COSHH Datasheet: Download 0633
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
EUH066 Repeated exposure may cause skin dryness or cracking
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P233 Keep container tightly closed.
P261 Avoid breathing dust/fume/gas/mist/vapours/ spray.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/…
P370 + P378 In case of fire: Use… to extinguish.
P303 + P361 + P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water.
GHS02 Flammable
GHS07 Health hazard/Hazardous to the ozone layer